There is a company that appears in the yellow pages as “Computer Emergency & Consulting Group Inc” at the address, and connected to that is some YouTube videos of a couple of people who are doing magic tricks. The domain is registered to an individual named Mitch Geier, and the address according to Zillow is to a single family home in NJ. If you hop up to the top level, the organization claims to have been around since 1978, but the site is just a bit flash with a rolling trailer. I would suggest a bit more caution when considering applying the above firmware. Generally you will NOT be supported by any warranty if you have a problem and used a “non-official” firmware release on your devices. Now just to be clear - I cannot vouch for the reliability or authenticity of this link, I don’t know who posted it other than it appears to be someone working with technology, and it showed up on the first page of Google results. This leads me to think that Homeseer is not developing the firmware on their own, but working with Dragon Tech to distribute firmware for their branded devices. Interestingly enough I do seem to be having a bug where if the switch is turned on it will immediately turn off and then back on again - so I think the thrashing problem is still there.
#Homeseer crack upgrade
Prior to the firmware upgrade the WS-100 were running 5.5 and the WD-100 were running 5.6. I took a chance and tried to upgrade my switches - SUCCESS! I can confirm I’m running 5.14 on all my Dragon Tech WS-100 switches and 5.13 on my WD-100. HEX extension for the WS-100, and 5.13 for the WD-100. HEX extension.Īfter much searching I found one (only ONE!) site where I could see there was the 5.14 and 5.13 firmware files with the. HEC extension, and the error was saying I needed a firmware file with an.
#Homeseer crack download
I could not get the Homeseer firmware file to download to a Dragon Tech switch, the Homeseer firmware file has an. I have Homeseer added as a secondary controller in my network.
#Homeseer crack license
I recently bought a Homeseer license and Z-Wave Network Adapter because I wanted to get better information from the Z-Wave side of the network and to perform firmware upgrades when needed. I was curious if I could upgrade them as well. I bought it in December 2012 from Homeseer.I have around 9 WS-100 and 1 WD-100 Dragon Tech branded switches that I bought late last summer, before Homeseer released their rebranded version.
Shouldn't I get something if I'm disconnected from the panel but plugged in via USB?Īny other ideas to try to bring the AD2USB to life or confirm it's dead? If disable the Homeseer plugin and try to connect with Putty, I connect to COM4 without any errors but "=" or no other commands do anything at all. Homeseer doesn't complain at this time although before it'd connect and later say it'd disconnected. However, the AD2USB is flashing as if it is receiving traffic. The ready light on the alarm panel also goes off. If I connect the AD2USB into the alarm (RJ45 jack near my PC) I immediately get a "Open Ckt" error on the alarm panel, and it beeps (more like a ding) every 10 seconds or so. Homeseer successfully initializes the Vista Alarm plugin and finds the AD2USB and reports the firmware version (v2.2a.6). Device manager says device is working properly. Panel and AD2USB via Homeseer have been working just fine until this afternoon. Having some issues and I think I've narrowed it down to the AD2USB.